COMMERCIAL CANOPY FILTERS
Designed for use in cooking exhaust systems.
Construction:
Kaleya honeycomb grease filters are made from high quality acid
resistant aluminum throughout. The filter media is made from 50mm
wide aluminum foil, which is specially corrugated into a herringbone
shaped channel. This foil when placed one on top of the other will
form a curved honeycomb channel. When the incoming grease laden
air passes through this media, the air changes direction. The resultant
change in inertia causes the grease to cling and condense onto the
aluminum surface. This prevents grease form entering the exhaust
system.
This honeycomb media is encased in a 50mm thick aluminum extruded
frame, which is screwed together. All frames have drain holes for
the cooking fat to drain in to the canopy channels. All filters
are fitted with steel plated retractable handles. Large D handles,
which are fitted offset, are also available on request at extra
cost.
Honeycomb filters are fully washable panel filter units. They provide
extremely low resistance to air flow and ease of cleaning.
Performance and Test Results:
Kaleya honeycomb grease filters have been laboratory tested by James M Fricker Pty Ltd. The results of this test are as follows:


Installation:
Kaleya honeycomb grease filters must always be installed with its face at not more than 30° from the vertical to minimize the possibility of grease dripping off the filter face. It is important to ensure that the filter is installed with the cell layer vertical i.e. with the handles on the vertical side of the filter. Under no circumstances must the filter be installed with the layer going horizontally.
Maintenance / Service:
Kaleya honeycomb grease filters must be cleaned regularly to minimize the possibility of collected grease dropping back in the semi – liquid form of the cell. Cleaners containing caustic solution must not be used as they will corrode the aluminum form which the unit is made.
Standard Available sizes and Prices:
